FUEL FILL ACCESS PLATE, FUEL FILL CAP AND FUEL STRAINER: REMOVAL AND INSTALLATIONMaterials/Parts:Dry-cleaning solvent (item 19, Appx D)REMOVALA Remove eight screws (1), eight flat washers (2) and eightlockwashers (3). Discard lockwashers.BRemove access plate (4).C Unscrew fill cap (5) from tank fill tube (6).D Pull fill cap (5) and chain (7) straight up and out of access open-ing grasp strainer assembly (8) and remove from vehicle.ERemove fill cap (5) and chain (7) from strainer assembly (8) byreleasing hook (9).INSTALLATIONABCDEWARNINGDry-cleaning solvent (PD-680) is toxic and flam-mable. To prevent personal injury when usingPD-680, use only in a well ventilated area. Avoidbreathing vapors. If you become dizzy get freshair immediately and seek medical attention. Avoidcontact with eyes, skin and clothing. Use protec-tive goggles, gloves, and clothing. If contact ismade, immediately flush with water and seekmedical attention. The flashpoint for Type I dry-cleaning solvent is 100°F (380°C); for Type II it is138°F (50°C). Do not use near open flame or ex-cessive heat.Clean strainer assembly (8) mesh with dry-cleaning solvent (item19, Appx D), or discard if strainer mesh is torn.Install fill cap (5) and chain (7) on strainerhook (9).Install strainer assembly (8) in vehicle.Screw fill cap (5) into tank fill tube (6).assembly (8) usingInstall access plate (4) using eight screws (1), eight flat washers(2) and eight new lockwashers (3).TA3127284-5Change 1TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
