FUEL TANK LEVEL TRANSMITTER (LOWER): REMOVAL AND INSTALLATION

FUEL TANK LEVEL TRANSMITTER (LOWER): REMOVAL AND INSTALLATION - TM-9-2350-267-20_458

FUEL CHECK VALVE (RIGHT AND LEFT): REMOVAL AND INSTALLATION

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
422

I I 1 FUEL TANK LEVEL TRANSMITTER (LOWER): REMOVAL AND INSTALLATION (CONTINUED) REMOVAL INSTALLATION A Remove six self-locking nuts (1), screw (2), and flat washer (3). NOTE Discard nuts. Apply sealing compound (item 54, Appx D) to new B Remove nut (4) and flat washer (5). gasket before installation. C Remove two nuts (6) and two flat washers (7). A Install new gasket (20) and transmitter (19) in lower fuel tank (21). D Loosen locknut (8) and screw (9) enough to remove angle bracket (10) from bulkhead. B Install ground lead (18), five screws (16) and five flat washers (17). E Remove stiffener (11) from heat shield (12). C Connect electrical connector (15). F Remove bar (13) and access cover (14). D Install access cover (14) and bar (13). G Disconnect electrical connector (15). E Install stiffener (11) on heat shield (12). H Remove five screws (16), five flat washers (17) and ground lead (18). F Install angle bracket (10) on bulkhead, and tighten screw (9) and locknut (8). I Remove transmitter (19) and gasket (20) from lower fuel tank (21). Discard gasket. G Install two nuts (6) and two flat washers (7). H Install nut (4) and flat washer (5). I Install screw (2), flat washer (3) and six new self-locking nuts (1). TA312733 4-8.1/(4-8.2 blank) Change 1 TM 9-2350-267-20

Privacy Statement
Press Release
Contact