TM 9-2350-261-34
Remove four screws (1), lockwashers (2),
22.
washers (3), and cable guard (4) securing
connector W8J1 (5) to floor near left
bulkhead. Disconnect connector W8J1 from
turret slip ring wiring harness connector.
Discard lockwashers.
23.
Cut safety wire securing connector W8J1 (5)
to screw (6). Remove screw (6), three screws
(7), four lockwashers (8), eight washers (9),
four nuts (10) and connector W8J1 (5) from
bracket (11). Discard lockwashers.
24.
Remove two screws (12), lockwashers (13),
washers (14), clamps (15) and wiring
harness (16) from left bulkhead. Discard
lockwashers.
Remove screw (17), lockwasher (18),
washer (19) and clamp (20) securing smoke
grenade arming/fiting unit lead W8P1 (21)
to rear engine compartment bulkhead.
Discard lockwasher.
Disconnect wiring harness lead W8P1 (21)
from smoke grenade arming/firing unit
connector (22).
6-58
20.
21.