N O D C O U T P U T F R O M D C P O W E R S U P P LY

VEHICLE WILL NOT ACCEPT EXTERNAL AC POWER (cont) - TM-9-2350-261-34_107

N O D C O U T P U T F R O M D C P O W E R S U P P LY (cont)

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
83

TM9-2350-261-34 N O D C O U T P U T F R O M D C P O W E R S U P P LY INITIAL SETUP Tools: General Mechanic’s Tool Kit (Item 35, App B) Digital multimeter (Item 62, App B) Fabricated Tool (page 2-4 Sec III f(1)) Personnel Required: Power-Generation Equipment Repairer 52D10 Helper (H) References: see your -10 See your -20 TM11-7010-256-12&P See M1068 wiring diagram (see your -20, FO -9 thru -11) Equipment Conditions: Power control enclosure removed (see your -20) Power control enclosure faceplate lowered and power supply cover removed (see your -20) Unit Level troubleshooting completed (see your -20) WARNING HIGH VOLTAGE is used in operation of this equip- ment. DEATH ON CONTACT may result if personnel fail to observe safety precautions. NEVER work on equipment unless at least one other person familiar with oper- ation and hazards of equipment is near- by. That person should also be familiar with giving first aid. When an operator helps a mechanic, that operator must be warned about dangerous areas. SHUT OFF POWER supply to equipment before beginning work. Make sure all external power is OFF/disconnected. BE CAREFUL not to touch high-voltage connections when installing or operating this equipment. 2.1-64 Change 3

Privacy Statement
Press Release
Contact