TM 9-2350-261-20-4
REPLACE M13 NBC HEATER HOSES (M1068 ONLY) -- Continued
0682 00
INSTALLATION
1.
Install rear operator's inlet hose (14) and two clamps (18) on rear operator's heater (4) and manifold (19). Tighten
clamps.
2.
Install two clamps (17) on rear operator's inlet hose (14) Secure clamps on sponson with two screws (15) and new
lockwashers (16).
3.
Secure electrical leads to rear operator's inlet hose (14) with new tie straps (13).
4.
If bracket (9) was removed, install bracket on table supports with four screws (10), washers (11), and new lockwashers
(12).
5.
If either bracket (5) was removed, install bracket (5) on bracket (9) with two screws (6), washers (7), and new locknuts
(8).
6.
Install rear operator's outlet hose (2) and two clamps (1) on connector (3) and rear operator's heater (4). Tighten clamps.
