TM 9-2350-261-20-4
REPLACE M13 NBC HEATER HOSES (M1068 ONLY) -- Continued
0682 00
7.
Install forward operator's inlet hose (1) and two clamps (2) on forward operator's heater (3) and manifold (4). Tighten
clamps.
8.
If bracket (5) was removed, install bracket on table supports with two screws (6), washers (7), and new locknuts (8).
9.
If any of three brackets (9) was removed, install bracket (9) on bracket (5) with two screws (10), washers (11), and
new locknuts (12).
10. Install forward operator's outlet hose (13) and clamp (14) on connector (15) and forward operator's heater (3). Tighten
clamp.
11. If grommet (16) was removed, install new grommet on commander's inlet hose (17). Route hose through welded
frame and insert grommet.
12. Install commander's inlet hose (17) and two clamps (18) on commander's heater (19) and manifold (4). Tighten clamps.
13. Install three clamps (20) on commander's inlet hose (17). Secure clamps on crossbeam with three screws (21), washers
(22), and new locknuts (23).
14. Install clamp (24) on commander's inlet hose (17). Secure clamp on commander's bulkhead with screw (25) and new
lockwasher (26).
15. Secure electrical leads to commander's inlet hose (17) with new tie straps (27).
16. If lower bracket (28) was removed, install bracket on commander's bulkhead with two screws (29) and new lockwashers
(30).
17. If upper bracket (31) and spacer (32) were removed, install bracket and spacer on commander's bulkhead with two
0682 00-6