TM 9-2350-261-20-2
REMOVE/INSTALL BATTERY LEADS (M1068 ONLY)
DESCRIPTION
This task covers: Remove (page 13-6.3). Clean, Inspect, and Repair (page 13-6.4).
Install (page 13-6.5).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Battery Terminal Cleaner (Item 13, App D)
Battery Terminal Puller (Item 46, App D)
Materials/Park
Grease (Item 18, App C)
Sodium Bicarbonate (Item 55, App C)
Grommet (2)
Personnel Required:
Unit Mechanic
References:
see your -10
Equipment Conditions:
Engine stopped (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Battery access cover removed (page 13-6.1)
Battery ground lead disconnected (page 13-2)
eyes.
WARNING
CAUTION
Gas from batteries can ex-
Do not start earners without batteries
plode and injure you. Do
installed. Starting engine with outside
not allow sparks near bat-
power will cause damage to electrical
teries. Battery acid can
components in the regulator.
bum or blind you. Do not
get acid on your skin or
REMOVE
1. Remove jumper lead (1) as follows:
W A R N I N G
Electrical current can bum
a.
you. Disconnect battery
ground lead before you
start task
Remove nut (2), jumper lead (l), and
screw (3) horn battery positive
terminal (4).
Remove nut (2), jumper lead (l), and
screw (3) from battery negative
GO TO NEXT PAGE
Change 3
13-6.3
b .
