TM 9-2350-261-20-223.24.25.Remove screw (1), one cradle (2), twolockwashers (3), circuit 48 connector groundlead (4), and capacitor (5) from weldnut (6),Disconnect circuit 48 lead (7) from capaci-tor (5).Remove four48 connectorscrews (8), nuts (9), and circuit(10) from bracket (11).26.27.28.29.30.31Disconnect circuit 38 lead (12) from domelight (13).Remove three screws (14), lockwashers (15),clamps (16), and circuit 38 lead (12) fromthree weldnuts (17). Discard lockwashers.Attach a cord (18) to circuit 38 lead ( 12).Pull lead through transverse beam (19) intodriver’s compartment. Untie cord from leadand leave it in transverse beam.If personnel heater is installed, disconnectcircuit 400 lead (20 ) from heater control boxlead.If engine coolant heater is installed,disconnect circuit 400A lead (21 ) fromengine coolant heater control box lead.Remove three cradle clips (22) and rearmain wiring harness (23 ) from three cradles(24 ) in driver’s compartment.GO TO NEXT PAGE12-109
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business