REPLACE FUEL TANK-TO-BULKHEAD HOSES, TUBES, AND FITTINGS (M113A2, M901A1, AND M1059 ONLY)

TEMPORARY FUEL TANK REPAIR (M113A2, M1059, M901A1 M1068, AND M577AZ ONLY) CONT.

REPLACE FUEL TANK-TO-BULKHEAD HOSES, TUBES, AND FITTINGS (M113A2, M901A1, AND M1059 ONLY) CONT.

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
675

TM 9-2350-261-20-1 REPLACE FUEL TANK-TO-BULKHEAD HOSES, TUBES, AND FITTINGS (M113A2, M901A1, AND M1059 ONLY) DESCRIPTION This task covers: Remove (page 6-23). Install (page 6-25). . INITIAL SETUP Tools: General Mechanics Tool Kit (Item 30, App D) Materials/Parts: Sealing compound (Item 46, App C) Wiping rag (Item 61, App C) Lockwasher (5) Strap (5) Personnel Required: Unit Mechanic References: see your -10 Equipment Conditions: Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Disconnect battery ground lead (page 13-2) Rear compartment floor plates removed (page 24-37, 24-42, or 24-45) Power plant rear access panel removed (page 24-27) REMOVE WARNING 1. 2. 3. 4. 5. 6. Fuel flowing over a metal surface causes static electricity. This will cause a spark unless the surface is grounded. NOTE Tag hoses and quick disconnects before removing. Use wiping rag to wipe up any spilled fuel. Drain fuel tank (page 6-5). Separate two quick-disconnect couplings (1) inside power plant rear bulkhead. Disconnect fuel supply hose (2) and fuel re- turn hose (3) from two bulkhead elbows (4). Remove two quick-disconnect coupling halves (5) from two elbows (6). Remove two elbows (6) from two tube assemblies (7). Remove two tube assemblies (7) from two bulkhead elbows (4). 7. Remove two nuts (8) and bulkhead elbows (4) from power plant rear bulkhead. 8. Remove five screws (9), washers (10), and two guards (11) from hull. GO TO NEXT PAGE 6-23

Privacy Statement
Press Release
Contact