TM 9-2350-261-20-1
61.
62.
63.
64.
Secure bracket (1) to hull with two screws
(2), new key washers (3), and flat washers
(4). Tighten screws to 40-45 lb-ft
(54-61 N•m) torque. Use torque wrench
(Item 97).
Install restraint plate (5) on bracket (1).
Secure with headed pin (6), new cotter pin
(7), and washer (8).
Install two ground leads (9 and 10), con-
denser (11), and wiring harness (12) on fuel
tank (13). Secure with clamp (14), two
washers (15), and screw (16).
Install wiring harness (12) on front end of
fuel tank (13). Secure with two clips (17),
cradles (18), and screws (19).
65.
66.
67.
68.
69.
Install wiring harness (12) on wiring har-
ness cover (20). Secure with three clamps
(21), screws (22), and new locknuts (23).
Install wiring harness (12) on wiring har-
ness guard (24). Secure with two clamps
(25), screws (26), and nuts (27).
Install guard (24) and ground lead (28) on
hull. Secure with two screws (29) and three
new lockwashers (30).
Install access cover (31) on cover (20).
Secure with two screws (32), new
lockwashers (33), and nuts (34).
Install cover (20) on fuel tank (13). Secure
with two screws (35) and new
lockwashers (36).
GO TO NEXT PAGE
6-19
