TM 9-2350-261-20-1
1.
2.
3.
4.
5.
6.
Set MASTER SWITCH to OFF.
Remove solo plug (1) from tested inverter IN1 (2) and
install in other inverter IN2 (3).
Set MASTER SWITCH to ON.
On inverter front panel (4), set POWER switch (5) to
ON and momentarily move RESET switch (6) up.
Measure voltage between sockets C and D of cable W5
plug P6 (7).
Does multimeter read 110 volts AC or more?
1. Install cable W5 plug P6 (1) on Power Control
Enclosure jack J27 (2).
2. Replace cascade remote harness W15 (page 40.1-26).
3. Verify no faults found.
NO
1. Faulty inverter IN2 (with
solo plug installed).
2. Notify your supervisor.
Change 3
3-226.119