TM 9-2350-261-20-1
1. Install cable W5 leads on terminal block TB2.
2. Remove cable W15 plugs (1) from inverters IN1 (2) and
IN2 (3).
3. Install inverter test solo plug (4) in inverter IN1 (2).
4. Set MASTER SWITCH to ON.
5. On inverter front panel (5), set POWER switch (6) to
ON and momentarily move RESET switch (7) up.
6. Measure voltage between sockets A and B of cable W5
plug P6 (8).
7. Does multimeter read 110 volts AC or more?
3-226.118
Change 3
1. Faulty inverter IN1 (with
solo plug installed).
2. Notify your supervisor.