NO POWER FROM DC POWER EXTENSION BOX A9, JACK J23 ( J T I D S) .... CONT.

NO POWER FROM DC POWER EXTENSION BOX A9, JACK J23 ( J T I D S) .... CONT. - TM-9-2350-261-20-1_476

NO DC POWER TO SINGLE POINT LAN GROUND BOX A15 (M1068 ONLY)

TM-9-2350-261-20-1 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
447

TM 9-2350-261-20-1 1. Turn MASTER SWITCH to OFF (see your -10). 2. Remove ten screws (1) and lockwashers (2), and lower faceplate (3). Discard lockwashers. 3. Turn ON JTIDS circuit breaker CB11 (4). 4. Measure resistance between terminals 1 and 2 (5) of circuit breaker CB11 (4). 5. Does multimeter read 0 ohms? 1. Raise faceplate (1) and secure to Power Control Enclo- sure with ten new lockwashers (2) and screws (3). 2. Go to: Power Control Enclosure A1 DC Input/Output Inoperative (page 3-226.1). 1. Replace circuit breaker CB11 (page 40.1-33). 2. Verify no faults found. 3-226.42 Change 3

Privacy Statement
Press Release
Contact