TM 9-2350-261-20-1
1.
2.
3.
4.
5.
6.
Remove ALL power from SICPS system,
(see your -10 and TM 11-7010-256-12&P).
Remove ten screws (1) and lockwashers (2), and lower
faceplate (3). Discard Iockwashers.
Apply AC power to the SICPS system,
(see your -10 and TM 11-7010-256-12&P).
Set AC TENT INTERFACE PANEL circuit breaker to
ON, (see TM 11-7010-256-12&P).
Measure voltage between terminal 1 (4) of circuit
breaker CB10 (5) to anywhere on bus bar E4 (6). Re-
peat measurement for terminal 2 (7) to bus bar E4.
Does multimeter read 110 volts AC for each
measurement?
GO TO N E X T P A GE
1. Replace circuit breaker CB10
(page 40.1-33).
2. Verify no faults found.
Change 3
3-226.17
