TM 9-2350-261-20-1
1.
2.
3.
4.
5.
6.
7.
Remove jumper wire.
Install engine harness circuit 33 plug on water
temperature transmitter.
Install jumper wire between front main harness
jack (1) pin E (2) and ground (at bulkhead).
Remove instrument panel for access. See task:
remove instrument panel mounts and ground lead
(page 11-2).
Remove front main harness circuit 33 plug (3) from
TEMP indicator jack (4).
Measure resistance between front main harness
circuit 33 (3) and ground.
Does multimeter read 0 ohms?
1. Remove jumper wire.
2. Install engine harness plug onto front main harness
jack at carrier bulkhead.
3. Replace TEMP indicator (page 11-11).
4. Verify no faults found.
1. Remove jumper wire.
2. Repair front main harness
circuit 33 (page 14-3).
3. Verify no faults found.
I
3-147