POWER ENTRY BOX
TM 9-2350-261-10
ASSEMBLY M1068 ONLY
WARNING
When using external power,
ensure proper grounding pro-
cedures are followed. Failure
to do so may result in personal
injury and/or damage to the
equipment. See TM 11-7010-
256-12&P for installing surface wire ground-
ing system.
serve safety
WARNING
HIGH VOLTAGE is used in
the operation of this equip-
m e nt
DEATH ON CONTACT may
result if personnel fail to ob-
precautions.
NEVER work on equipment unless at least
one other person familiar with the operation
and hazards of the equipment is nearby.
That person should also be competent in
giving first aid. When an operator helps a
technician, that operator must be warned
about dangerous areas.
SHUT OFF POWER supply to equipment
before beginning work. When working in-
side equipment with power off, take special
care to ground every capacitor likely to hold
a dangerous potential.
BE CAREFUL not to contact high-voltage
connections when installing or operating
this equipment.
KEEP one hand away from the equipment
to reduce the hazard of current flowing
through life-sustaining organs of the body.
The power entry box assembly, located at the upper rear roadside exterior comer of
the carrier, along with cable W1 (external power input pigtail), and cable W2
(external A.C. power cable) provides the ability to receive or supply A.C. power. A
workstation can be powered by using the on-board generator, external power source,
or the carriers charging system.
Change 3
1-36.1