TM 9-2350-247-34
REPLACE/FABRICATE CARGO COVER HEAT SHIELD Continued
0060 00
FABRICATE
1.
Cut two pieces of 0.090 inch (2.29 mm) thick aluminum sheet to 12 x 1 5 inches (30.48 x 38.1 cm).
2.
Cut two pieces of 0.090 inch (2.29 mm) thick aluminum sheet to 4-3/4 x 1 2 inches (12.07 x 30.48 cm).
3.
Lay out locations in one aluminum piece for four 13/64 inch (5.16 mm) holes as shown.
4.
Sandwich four aluminum pieces at one end of 12 inch (30.48 cm) side, drill four 13/64 inch (5.16 mm) holes through,
and install four rivets.
5.
Lay out locations on one aluminum piece for four 9/32 inch (7.14 mm) holes as shown. Drill four 9/32 inch (7.14 mm)
holes through the two larger aluminum sheets.
0060 00-2