TM 9-2350-247-34
INSTALL CARGO COVER/INSULATION KIT (SECONDARY KIT) — Continued
0059 00
18. Remove four nuts (1), eight washers (2) and four screws (3) that secure heater exhaust (4) to heater support (5). Store
nuts, screws, and washers with cover.
19. Position plate (6) and guard (7) on heater support (5) and secure with four screws (3), spacers (8), 12 washers (2) and
four nuts (1). Use spacers (8) and washers (2) as required to obtain a common surface between the rear face of plate (6)
and front face of rear flange of heater mounting bracket (9).
20. Install two screws (10), washers (11) and nuts (12) to secure guard (7) to flange of heater mounting bracket.
21. Plug weld four loops (13) to top of cargo door (14). Inside edges of inner loops should be 6-3/8 inches (16.19 cm) from
center line of door. Inside edge of outer loops should be 34-1/8 inches (86.68 cm) from center line of cargo door. Rear
edge of loops should be 3/8 inch (9.5 mm) from front side of door.
22. Position three fastener tapes (15) on rear of cargo door (14) and drill fifteen 0.159-0.172 inch (4.04-4.37 mm) diameter
holes through tapes and other cargo door panel. Secure 3 tapes to cargo door with 15 blind rivets.
0059 00-7
