TM 9-2350-247-20-3
REPLACE WINDSHIELD WIPER MOTOR — Continued
0420 00
INSTALLATION
1.
Place pivot post of windshield wiper motor (1) through hole in bracket (2).
2.
Install three screws (3) and six new lock washers (4) to secure windshield wiper motor (1) to bracket (2). Place washers
on each side of bracket. Do not tighten screws.
3.
Slide clamp (5) over end of windshield wiper motor (1). Secure clamp to bracket with screw (6) and new lock nut (7).
Tighten all screws.
4.
Place end of link (8) on pivot post of windshield wiper motor (1). Install washer (9) and clip (10) on pivot post.
5.
Install capacitor (11) on weldnut (12) with screw (13).
6.
Pull nipple (14) back and install washer (15), lead (16), washer (15), and capacitor lead (17) on screw (18). Install screw
in windshield wiper motor (1).
FOLLOW-THROUGH STEPS
1.
Connect battery negative lead(s) (WP 0292 00).
2.
Check windshield wiper motor for proper operation.
3.
Turn windshield wiper switch OFF (see your -10).
END OF TASK
0420 00-3/4 blank
