TM 9-2350-247-20-2
ADJUST PIVOT STEERING BRAKE CONTROLS/LINKAGE (M548A1) -- Continued
0370 00
NOTE
Right and left brake assemblies are bled the same way, one at a time.
Do not release handle while brake bleeders are open.
2.
Bleed pivot steering brake control lines as follows:
a.
Pull right or left hand lever (1) back hard and hold in applied position.
b.
Open two brake bleeders (2) on right or left brake assembly (3), one at a time. Leave each bleeder open until
discharge is free of bubbles, then close bleeders.
c.
Recheck fluid level in two master cylinders (4) (see your PMCS) (WP 0128 00).
FOLLOW-THROUGH STEPS
1.
Start engine (see your -10).
2.
Check pivot steering brake controls/linkage for proper operation.
3.
Stop engine (see your -10).
4.
Lower center floor plates (WP 0394 00).
END OF TASK
0370 00-3/4 blank
