TM 9-2350-247-20-2
ADJUST PIVOT STEERING BRAKE CONTROLS/LINKAGE (M548A1) -- Continued
0370 00
f.
Turn two rod end bearings (7) out, one full turn. One full turn will provide a minimum of 1/32 in (.8 mm) play
between master cylinder clevises (12) and master cylinder pistons (13).
g.
Secure two rod end bearings (7) to two outer shaft levers (11) with two screws (8), washers (9), and new lock nuts
(10). Tighten two jam nuts (6) on rod end bearings.
h.
Remove filler cap on two master cylinders (5). Check fluid level. Add hydraulic fluid as needed (see your
PMCS)(WP 0128 00).
0370 00-2