TM 9-2350-247-20-2
REPLACE STARTER (M548A1) -- Continued
0253 00
INSTALLATION
NOTE
Check that starter-to-engine housing gasket is in place. Gasket is necessary to keep water out of
starter.
1.
Install gasket (1) on engine (2).
2.
Place starter (3) with solenoid (4) on engine (2). Secure with three new lock washers (5) and bolts (6). Tighten bolts to
137-147 lb-ft (186-199 Nm) torque. Have helper assist.
3.
Install new lock washer (7) (Delco and Leece Neville only) and circuit 74A lead (8) on terminal of starter solenoid (4).
Secure with nut (9) (screw on Prestolite).
4.
Install new lock washer (10) and circuit 6 lead (11) on terminal of solenoid (4). Secure with nut (12).
5.
Install new lock washer (13) and two ground leads (14) on terminal of starter (3). Secure with nut (15).
FOLLOW-THROUGH STEPS
1.
Install power plant (WP 0130 00).
END OF TASK
