TM 9-2350-247-20-2
REPLACE/ADJUST GENERATOR DRIVE BELT (M548A3)
THIS WORK PACKAGE COVERS:
Removal (page 0245 00-1).
Inspection-Acceptance and Rejection Criteria (page 0245 00-1).
Installation (page 0245 00-2).
INITIAL SETUP:
Maintenance Level
Personnel Required
Unit Mechanic
Unit
References
Tools and Special Tools
See your -10
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Straight Edge (WP 0541 00, Item 50)
Equipment Condition
V-belt Tensiometer (WP 0541 00, Item 59)
Engine stopped (see your -10)
Socket Wrench Set (WP 0541 00, Item 64)
Carrier blocked (see your -10)
Torque Wrench (WP 0541 00, Item 71)
Power plant rear access panel removed (see your -10)
REMOVAL
1.
Loosen generator mounting screw (1) and locking nut (2) and rotate turnbuckle (3) clockwise to relieve tension on drive
belt (4). Remove drive belt from two pulleys (5).
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
1.
Inspect drive belt for broken, cracked, or frayed conditions. Replace drive belt that shows any of these defects.
