TM 9-2350-247-20-2
REPLACE FUEL CUTOFF CONTROL CABLE ASSEMBLY (M548A3) -- Continued
0205 00
INSTALLATION
1.
Install pin (1) on engine governor fuel cutoff lever (2). Secure with washer (3) and new cotter pin (4).
2.
Install grommet (5) in bulkhead, if removed.
NOTE
When installing fuel cutoff control cable assembly, hold securing nut and washer behind
mounting hole in instrument panel and insert fuel cutoff control cable assembly through hole,
washer and nut at same time.
3.
Install fuel cutoff control cable assembly (6) in instrument panel mounting hole. Secure with washer (7) and nut (8).
4.
Route fuel cutoff control cable assembly (6) under the floor through battery compartment, through grommet (5).
