TM 9-2350-247-20-2
ADJUST FUEL CUTOFF HAND CONTROL
THIS WORK PACKAGE COVERS:
INITIAL SETUP:
Maintenance Level
Equipment Condition
Unit
Engine stopped (see your -10)
Tools and Special Tools
Carrier blocked (see your -10)
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Left center seat floor plate raised/removed (WP 0394 00
Personnel Required
or WP 0395 00)
Unit Mechanic
Cab personnel seats raised (see your -10)
References
Power plant rear access door/panel removed
(see your -10)
See your -10
ADJUSTMENT
NOTE
Fuel cutoff hand control is adjusted the same way for M548A1 and M548A3. M548A1 hand
control is shown.
Orientation of power plant is different in M548A1 and M548A3.
1.
Adjust fuel cutoff hand control as follows:
a.
Loosen two setscrews (1) in two retainer collars (2) to release fuel cutoff control cable (3).
b.
Pull fuel cutoff control cable (3) to full out position (engine off).
c.
Turn engine stop lever (4) to the right against stop in engine governor housing.
d.
Insert fuel cutoff control cable (3) through retainer collar (2), link pin (5), and retainer collar (2).
e.
Place two retainer collars (2) against link pin (5). Tighten two setscrews (1) in collars to secure fuel cutoff control
cable (3).