TM 9-2350-247-20-2
REPLACE FUEL COMPARTMENT TUBES, HOSES, AND FITTINGS
(M548A3)
THIS WORK PACKAGE COVERS:
Removal (page 0166 00-1).
Installation (page 0166 00-6).
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Equipment Condition
Materials/Parts
Engine stopped (see your -10)
Sealing compound (WP 0542 00, Item 37)
Carrier blocked (see your -10)
Grommet (3)
Both battery negative leads disconnected (WP 0292 00)
Lock washer (14)
Cargo compartment floor plates removed (WP 0393 00)
Preformed packing
Fuel compartment access covers removed (WP 0163 00)
Seal (2)
Suitable container
Fuel compartment drained (WP 0162 00)
Power plant rear access panel removed (see your -10)
Personnel Required
Top access cover and grilles removed (see your -10)
Unit Mechanic
REMOVAL
NOTE
Removal of all tubes, hoses, and fittings is not usually needed for maintenance. Remove only
those parts needed to do the task.
Remove tubes and hoses with clamps attached. Attach clamps to replacement tubes and hoses.
1.
Remove eight screws (1), lock washers (2), four metal straps (3), and rubber strips (4) from four blocks (5) that secure
tubes to hull. Discard lock washers.
