TM 9-2350-247-20-1BLOCK POWER PLANT (M548A1) — Continued 0132 004. Stack a 4 x 6 x 1 0 inch (10 x 1 5 x 25 cm) block (1), a2 x 4 x 10 inch (5 x 1 0 x 25 cm) block (2), and a1 x 4 x 10 inch (3x 1 0 x 25 cm) block (3) under transmission side of transfer gearcase. Blocks should be 8 inches (20 cm) high.5. Stack a 4 x 6 x 1 8 inch (10 x 1 5 x 46 cm) block (4) and a2 x 4 x 18 inch (5 x 1 0 x 46 cm) block (5) under rear of engine.Blocks should be about 7 inches (16 cm) high.6. Lower power plant slowly down onto blocks. Check that power plant is firmly supported by the blocks.7. Cover air inlet housing (6). Use wiping rag.FOLLOW-THROUGH STEPS1. Install power plant in carrier (WP 0130 00).END OF TASK0132 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
