TM 9-2350-247-20-1
REMOVE/INSTALL POWER PLANT (M548A1) Continued
0130 00
NOTE
Make sure ball sockets of exhaust pipe (5) are lined up with left crossover pipe (6) before you
tighten clamps. This is to keep ball sockets from leaking exhaust gases.
8.
Install engine exhaust pipe on muffler and left crossover pipe.
a.
Install exhaust pipe (5) on left crossover pipe (6). Turn exhaust pipe install on ball joint to line up with muffler (7).
Install clamp (8).
b.
Tighten nut on clamp (8) to 200-220 lb-in (23-25 Nm) torque.
c.
If needed, tighten nuts on clamp (9) and clamp (10) to 200-220 lb-in (23-25 (Nm) torque to secure exhaust pipe (5)
to right crossover pipe (6).
9.
Install rear fan drive belts on jackshaft pulley.
a.
Install two rear fan drive belts (11) on jackshaft pulley (12).
b.
Adjust belt tension by turning belt adjuster (13) (WP 0226 00).
0130 00-17