POWER TAKEOFF DOES NOT ENGAGE WHEN WINCH CONTROL IS ACTUATED (M548A1)

POWER TAKEOFF DOES NOT ENGAGE WHEN WINCH CONTROL IS ACTUATED (M548A1)Continued

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
365

TM 9-2350-247-20-1 POWER TAKEOFF DOES NOT ENGAGE WHEN WINCH CONTROL IS ACTUATED (M548A1) 0093 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Power plant upper rear access door removed (see your -10) Center seat raised (see your -10) Center floor plates removed (WP 0394 00) T 1. Check for broken winch control cable (1) on power takeoff control (2) (WP 0414 00). 2. Is control cable (1) properly connected? YES NO TN 1. Replace or connect control cable (WP 0414 00). 2. Verify no faults found. 0093 00-1

Privacy Statement
Press Release
Contact