WINCH DRUM DOES NOT TURN WITH DRUM CLUTCH IN CLUTCH IN POSITION (M548A1)

WINCH DRUM DOES NOT TURN WITH DRUM CLUTCH IN CLUTCH IN POSITION (M548A1)Continued

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
360

TM 9-2350-247-20-1 WINCH DRUM DOES NOT TURN WITH DRUM CLUTCH IN “CLUTCH IN” POSITION (M548A1) 0090 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Winch cable reeled out (see your -10) T 1. Check winch cable (1) (WP 0416 00). 2. Has winch cable been released from carrier? YES NO TN 1. Release winch cable (see your -10). 2. Verify no faults found. Y 1. Verify proper operation (see your -10). 2. Check for faulty or broken poppet shaft (1). 3. Is poppet shaft in good condition? YES NO YN 1. Broken or stuck poppet shaft. 2. Notify your supervisor. 2Y 1. Check for worn or damaged drive clutch. 2. Is clutch holding? YES NO 2YN 1. Damaged clutch. 2. Notify your supervisor. 0090 00-1

Privacy Statement
Press Release
Contact