EXCESSIVE OIL LEAKS (WINCH TRANSFER GEARCASE AND POWER TAKEOFF) (M548A1)

POWER TAKEOFF DOES NOT ENGAGE WHEN WINCH CONTROL IS ACTUATED (M548A1)Continued

WINCH PROPELLER SHAFT NOISY DURING OPERATION (M548A1)

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
367

TM 9-2350-247-20-1 EXCESSIVE OIL LEAKS (WINCH TRANSFER GEARCASE AND POWER TAKEOFF) (M548A1) 0094 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) T 1. Check for worn oil seals in winch transfer gearcase (1) and power takeoff (2). 2. Are seals in place and in good condition? YES NO TN 1. Replace damaged seals. 2. Verify no faults found. Y 1. Check for loose cover plates and damaged gaskets. 2. Are covers tight and gaskets in good condition? YES NO YN 1. Replace gasket and tighten cover or replace transfer gearcase (WP 0413 00). 2. Verify no faults found. 2Y 1. Notify your supervisor of cracked housing. 2. Verify no faults found. 0094 00-1/2 blank

Privacy Statement
Press Release
Contact