|
| |
TM 9-2350-287-20-2
11-14. TRACK REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Track connecting fixture (2) (Item 71, Appendix I)
Crowbar (Item 12, Appendix I)
Track end connector puller (2) (Item 72,
General mechanic's tool kit
Appendix I)
(Item 24, Appendix I)
Socket wrench socket, 1 1/8-inch, 3/4-inch drive
Materials/Parts:
(Item 60, Appendix I)
Track end connector kit (Item 376, Appendix H)
Socket wrench handle, 3/4-inch drive
(Item 61, Appendix I)
Personnel Required: Two
Socket wrench socket,1 1/2-inch, 3/4-inch
drive (Item 62, Appendix I)
Equipment Conditions:
Torque wrench, 0-600 ft-lb
Vehicle parked on level ground (refer to
(Item 70, Appendix I)
TM 9-2350-287-10).
a.
REMOVAL
1.
Position
track
disconnection
point
midway between No. 7 roadwheel (1)
and idler wheel (2).
2.
Shut off vehicle engine (refer to TM
92350-287-10), and block track with
chock blocks. Do not set parking
brake.
3.
Decrease track tension (refer to TM
92350-287-10).
4.
Remove two bolts (4) from opposite
end connectors (3). Discard bolts.
Change 1 11-32
|
