| |
19-3. STE/lCE FUEL PRESSURE TRANSDUCER AND DIFFERENTIAL SWITCH
REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
. General mechanic's tool kit (Item 24,
Appendix I)
Materials/Parts:
. Cap and plug set (Item 13, Appendix D)
. Rag (Item 56, Appendix D)
. Teflon pipe sealant (Item 63, Appendix D)
Equipment Conditions:
. Vehicle parked on level ground (refer to
TM 9-2350-287-10).
. MASTER switch set to OFF (refer to
TM 9-2350-287-10).
. Battery ground cables disconnected (para 7-42).
. Transmission access doors opened
(refer to TM 9-2350-287-10).
a.
1.
2.
3.
4.
5.
6.
7.
8.
REMOVAL
CAUTION
Cap all fuel, oil, air, or engine component openings with protective covers. Do not use
tape to seal fuel or oil openings. Tape adhesive can contaminate fuel and oil.
Disconnect wiring harness connector (12) from STE/lCE fuel pressure transducer (11).
Remove fuel pressure transducer (11) from elbow (10).
NOTE
Note position of fittings before removing.
Remove elbow (10) from fuel fitter (9).
Disconnect wiring harness connector (7) from differential switch (6).
Loosen nut (4) at elbow (5), loosen nut (2) at tee (1), and remove tube (3) from elbow (5) and tee (1).
Remove elbow (5) from differential switch (6).
Remove differential switch (6) and elbow (8) from fuel filter (9).
Remove elbow (8) from differential switch (6).
19-4
TM 9-2350-287-20-2
|