|
| |
TM 9-2350-287-20-2
17-9. DRIVE-END SECTION ASSEMBLY REPAIR (continued).
3.
Remove clip (10), pin (14), and rubber latch (8) from bracket (9).
4.
Remove two screws (13), Iockwashers (12), washers (11), and bracket (9) from drive-end section (1). Discard
Iockwashers.
Do not remove chain from around takeup-end section.
5.
Remove 20 screws (15) from two side wearstrips (16). Pry up and remove two side wear strips (16) from drive-
end section (1).
6.
Remove 16 screws (17) and bottom wear strip (18) from drive-end section (1).
17-21
|
