|
| |
TM 9-2350-287-20-2
17-9. DRIVE-END SECTION ASSEMBLY REPAIR (continued).
7.
8.
b.
1.
2.
c.
1.
2.
3.
4.
Remove two screws (19), chain-return wear strip (20), and spacer (27) from drive-end section (1).
Remove 12 screws (24), washers (25), lockwashers (28), and nuts (29), six straps (26), wiring harness (23),
and two retaining strips (22) and chain guards (21 ) from drive-end section (1). Discard Iockwashers.
CLEANING AND INSPECTION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a weii-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
Clean all metal parts with drycleaning solvent.
Inspect all parts for cracks, rips, or other damage. Replace damaged parts.
INSTALLATION
lnstall two chain guards (21) and retaining strips (22), six straps (26), and wiring harness (23) on drive-end
section (1) with 12 screws (24), washers (25), new lockwashers (28), and nuts (29).
lnstall; spacer (27) and chain-return wear strip (20) on drive-end section (1) with two screws (1 9).
lnstall bottom wear strip (18) on drive-end section (1) with 16 screws (17).
Apply sealing compound to threads of 20 screws (15).
17-22
|
