|
| |
TM 9-2350-287-20-2
17-9. DRIVE-END SECTION ASSEMBLY REPAIR.
This Task Covers:
a. Removal
b. Cleaning and Inspection
c. Installation
Initial Setup:
Tools/Test Equipment:
l General mechanic’s tool kit (Item 24,
Appendix l)
Materials/Parts:
l Drycleaning solvent (Item 27, Appendix D)
l Sealing compound (Item 58, Appendix D)
l Lockwasher (23) (Item 164, Appendix H)
l Lockwasher (2) (Item 196, Appendix H)
Equipment Conditions:
l Vehicle parked on level ground (refer to
TM 9-2350-287-10).
l Conveyor assembly removed (para 17-6).
l Dead-end section removed from drive-end
section (para 17-8).
l Conveyor toggle clamp and tube removed
(para 17-18).
l Drive-end section coupling sprocket, pillow
blocks, and drive sprocket assembly
removed (para 17-14).
a.
REMOVAL
1.
Remove three nuts (7), Iockwashers (6), washers (5), and screws (3) from each of two hinge assemblies (4)
Discard Iockwashers.
2.
Remove conveyor drive-end section (1) from conveyor center section (2).
17-20
|
