| |
TM 9-2350-207-20-2
17-8. DEAD-END SECTION ASSEMBLY REPAIR (continued).
NOTE
Steps 6 through 9 apply to both dead-end section assemblies.
6.
Remove two setscrews (34) securing flipper block (28) to support bar (31).
7.
Remove two cotter pins (33) and washers (32) from support bar (31), and drive out support bar (31) from either
dead-end section assembly (1 or 5). Discard cotter pins.
8.
Remove flipper block (28) from either dead-end section assembly (1 or 5).
9.
Remove 10 screws (30) from each of two wear strips (29). Pry up and remove two wear strips (29) from either
dead-end section assembly (1 or 5).
NOTE
Steps 10 through 13 apply only to forward dead-end section assembly.
10.
Remove three screws (36) and bottom wear strip (35) from forward dead-end section assembly (5).
11.
Pry rubber strip (40) from forward dead-end section assembly (5). Discard rubber strip.
12.
Remove two screws (39) and Iockwashers (38) and gun clip (37) from forward dead-end section assembly
(5). Discard Iockwashers.
17-15
|