| |
TM 9-2350-287-20-2
17-8. DEAD-END SECTION ASSEMBLY REPAIR (continued).
13.
Remove
pins.
two cotter pins (43), washers (42), and pins (41) from forward dead-end section (5). Discard cotter
c.
ASSEMBLY
NOTE
Steps 1 through 5 apply only to forward dead-end section assembly.
1.
Install two pins (41 ) in forward dead-end section assembly (5) with two washers (42) and new cotter pins (43).
2.
Install gun clip (37) on forward dead-end section
assembly (5) with two new Iockwashers (38) and two
screws (39).
3.
Adhesives can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive gets
on skin or clothing, wash
immediately with soap and water.
Apply rubber adhesive to rubber strip (40)
dry until tacky.
Allow to
4.
Install rubber strip (40) on forward dead-end section
assembly (5).
5.
install bottom wear strip (35) on forward dead-end
section assembly (5) with three screws (36).
17-16
|