| |
TM 9-2350-287-20-2
10-3. POWERPACK COMPARTMENT BRAKE LINKAGE REPLACEMENT/ADJUSTMENT
(continued).
b.
DISASSEMBLY
1.
Loosen nut (20) on rod end (21). Unscrew and remove rod end (21) from clevis(19).
2.
Remove cotter pin (18), pin (17), sprocket (23), and chain (22) from clevis (19). Discard cotter pin.
3.
Remove two cotter pins (16), pins (15), and clevises (13) and chain (22) from right brake lever (24) and left
brake lever (12). Discard cotter pins.
4.
Remove two spring pins (14) from two clevises (13), and separate chain (22) from two clevises (13). Discard
c.
1.
2.
d.
1.
2.
spring pins.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
Clean all parts with drycleaning solvent and rag.
Inspect all parts for damage. Replace any damaged parts.
ASSEMBLY
Install two clevises (13) on ends of chain (22) with two new spring pins (14).
Position chain (22) and two clevises (13) in place on sprocket (23).
CLEANING AND INSPECTION
10-7
|