|
| |
TM 9-2350-287-20-2
15-58. DRIVER’S HATCH SEAL REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• Seal (Item 260, Appendix H)
• General mechanic's tool kit (Item 24,
Appendix I)
Equipment Conditions:
• Vehicle parked on level ground (refer to
Materials/Parts:
TM 9-2350-287-10).
• Adhesive, rubber (Item 5, Appendix D)
• Driver’s hatch cover opened and secured
• Drycleaning solvent (Item 28, Appendix D)
(refer to TM 9-2350-287-10).
• Rag (Item 56, Appendix D)
a.
REMOVAL
1.
Remove six screws (1) from driver’s hatch seal (2) and hatchway opening in hull.
2.
Remove hatch seal (2) from hatchway opening in hull. Discard seal.
3.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
Clean adhesive from hatch seal mounting surface around hatchway opening in hull with drycleaning solvent
and rags; then dry area thoroughly.
15-141
|
