|
| |
TM 9-2350-287-20-2
15-53. DRIVER’S HATCH COVER REPLACEMENT (continued).
e.
1.
2.
3.
4.
5.
6.
7.
INSTALLATION
Driver’s hatch cover is heavy. Two persons are required when installing driver’s hatch
cover.
With the aid of an assistant, position hatch cover (1) in place on vehicle. Raise hatch cover (1) to a vertical
position with splined hole in inner hatch cover arm (4) alined with holes in vehicle-mounted bracket (5), and
have assistant hold in place.
Install torsion bar hinge (14) through outer hatch cover arm (9) with grease fitting hole parallel to hatch cover
(1). Aline splined end of torsion bar hinge (14) with splined hole in inner hatch cover arm (4). Tap torsion bar
hinge (14) into inner hatch cover arm (4).
Install grease fitting (15) on torsion bar hinge (14).
Aline torsion bar anchor (16) with splined outer end of torsion bar hinge (14). Keep mounting surface of torsion
bar anchor (16) parallel to mounting surface of vehicle-mounted block (18), and tap torsion bar anchor (16)
onto torsion bar hinge (14).
Secure torsion bar anchor (16) to vehicle-mounted block (18) with two screws (17), washers (11), new
Iockwashers (12), and nuts (13).
Install striker (10) on outer hatch cover arm (9) with two screws (7), new Iockwashers (8), and washers (6).
Close driver's hatch cover (1). Install wear plate (2) on hatch cover (1) with two screws (3).
FOLLOW-ON MAINTENANCE:
•None
15-132
|
