|
| |
TM 9-2350-287-20-2
15-54. DRIVER’S HATCH COVER SEAL AND PAD REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• Pad (Item 210, Appendix H)
• General mechanic’s tool kit (Item 24,
• Seal (Item 272, Appendix H)
Appendix I)
Equipment Conditions:
Materials/Parts:
• Vehicle parked on level ground (refer to
• Adhesive, rubber (Item 5, Appendix D)
TM 9-2350-287-10).
• Drycleaning solvent (Item 28, Appendix D)
• Driver’s hatch cover open and secured
• Rag (Item 56, Appendix D) (as required)
(refer to TM 9-2350-287-10).
a.
REMOVAL
1.
Remove seal (2) from driver’s hatch cover (1). Discard seal.
2.
Remove pad (3) from driver’s hatch cover (1). Discard pad.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
3.
Clean adhesive from channel and underside of driver’s hatch cover (1) with drycleaning solvent and rag, then
dry thoroughly.
15-133
|
