|
| |
10-2. SERVICE AND PARKING BRAKE LINKAGE REPLACEMENT/ADJUSTMENT
(continued).
f.
1.
2.
3.
4.
5.
6.
7.
ADJUSTMENT
Remove two screws (5) and Iockwashers (6) to loosen angle bracket (7). Discard bckwashers.
Loosen two nuts (16 and 18) on brake control rods (9 and 19).
Turn mechanical post (17) in either direction until screw holes in angle bracket (7) lineup with mounting holes
in bulkhead and no pressure is on bellcrank (3).
Install two screws (5) and new Iockwashers (6) to secure angle bracket (7) to bulkhead.
Tighten two nuts (16 and 18) on brake control rods (9 and 19).
Depress service brake pedal (29), and pull brake handle (13) to lock parking brake.
Release service brake pedal (29). Brake should stay locked; if it does not, repeat steps 1 through 6.
FOLLOW-ON MAINTENANCE:
• Adjust parking brake light switch (para 7-20).
• Unblock tracks (refer to TM 9-2350-287-10).
10-5
TM 9-2350-287-20-2
|
