| |
TM 9-2350-287-20-2
15-47. COMMANDER'S ACCESS DOOR REPAIR (continued).
5.
6.
b.
c.
1.
2.
3.
d.
e.
1.
2.
3.
Remove spring pin (11) from pin (10),
and remove pin (10) from access door
(1). Discard spring pin.
Remove access door (1) from vehicle.
DISASSEMBLY
Remove two screws (13) and
Iockwashers (14) and handle (12) from
access door (1). Discard Iockwashers.
CLEANING AND INSPECTION
Remove dirt and adhesive from seal
seat.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors,
Clean all parts with drycleaning solvent.
Inspect parts for cracks, bends, or breaks.
ASSEMBLY
DO NOT use near open flames or excessive heat.
Replace damaged parts.
Install two new Iockwashers (14), two screws (1 3), and handle(12) on access door(1).
INSTALLATION
Install pin (10) on access door (1) and install new spring pin(11) in pin (10).
Coat 12 flat springs (3) with grease.
With the aid of an assistant, position and hold access cover (1) on vehicle in open position, so 12 flat springs
(3) can be installed.
15-118
|