|
| |
TM 9-2350-287-20-2
10-2. SERVICE AND PARKING BRAKE LINKAGE REPLACEMENT/ADJUSTMENT
(continued).
4.
5.
6.
7.
8.
c.
1.
2.
d.
1.
2.
3.
4.
5.
WARNING
Use care when removing spring. Spring is under tension and can act as a projectile
when released and could cause severe eye injury.
Remove cotter pin (20), two washers (24), spring (23), rod guide (22), and washer (21) from brake control
rod (19). Discard cotter pin and spring.
Remove screw (27), Iockwasher (26), washer (25), and rod guide (22) from bellcrank (3). Discard
Iockwasher.
Loosen two nuts (16 and 18) and remove two brake control rods (9 and 19) from mechanical post (17).
Remove nut (18) and two nuts (28) from brake control rod (19).
Remove nut (16) from brake control rod (9).
CLEANING AND INSPECTION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
Clean all parts with drycleaning solvent and rag.
Inspect all parts for damage. Replace any damaged parts.
ASSEMBLY
Install nut (16) on brake control rod (9).
Install two nuts (28) and nut (18) on brake control rod (19).
Install two brake control rods (9 and 19) in mechanical post (17), then tighten two nuts (16 and 18).
WARNING
Use care when installing spring. Spring is under tension and can act as a projectile
when released and could cause severe eye injury.
Install washer (21), rod guide (22), new spring (23), and two washers (24) on end of brake control rod (19),
and secure with new cotter pin (21 ).
Install bellcrank (3) on rod guide (22) and secure with screw (27), washer (25), and new Iockwasher (26).
10-3
|
