|
| |
TM 9-2350-287-20-2
10-2. SERVICE AND PARKING BRAKE LINKAGE REPLACEMENT/ADJUSTMENT
(continued).
a.
REMOVAL
1.
Remove screw (1) and Iockwasher (2) from
bellcrank (3). Discard Iockwasher.
2.
Remove two screws (5) and Iockwashers (6)
from angle bracket (7). Discard Iockwashers.
NOTE
Support service and parking brake
linkage by hand.
3.
Pull bellcrank (3) off bracket spindle (4), and
remove brake linkage (8) from vehicle.
b.
DISASSEMBLY
1.
Remove spring pin (14) and
end of brake control rod (9).
brake handle (13) from
Discard spring pin.
2.
3.
WARNING
Use care when removing spring. Spring is under tension and can act as a projectile
when released and could cause severe eye injury.
Remove angle bracket (7), two washers (11), and spring (12) from brake control rod (9). Discard spring.
Remove spring pin (15) and collar (1
0) from brake control rod (9). Discard spring pin.
10-2
|
