|
| |
15-24. CANISTER DOORS REPAIR (continued).
40
5.
6.
7.
8.
9.
100
While assistant stabilizes canister door (1), install plate spacer (8) and canister door (1) on hull with six screws
(13), nuts (11), new Iockwashers (10), and washers (9).
Remove sling from lifting lug (19) and hoist.
Close canister door (1). If canister door (1 ) is mounted straight and closes easily, go to step 8, If canister door
(1) binds or is mounted crooked, go to step 7.
While assistant supports door with crowbar, loosen six screws (13) and nuts (11). Reposition canister door
(1) until it is straight and does not bind; then tighten six screws (13) and nuts (11).
Close and latch canister door (1) (refer to TM 9-2350-287-10). If canister door (1) does not latch, go to step
9. If door latches properly, open canister door (1) and go to step 10.
Open canister door (1). Loosen four screws (3) and reposition latch (6) as necessary until canister door (1)
latches properly.
Apply sealing compound to screws (1 6), and install striker (18) on canister door (1) with two screws (16) and
two new Iockwashers (17). Position striker (18) on canister door (1) so striker (18) will properly hold canister
door (1) in full open position.
FOLLOW-ON MAINTENANCE:
• Close canister door (refer to TM 9-2350-287-10).
15-56
TM 9-2350-287-20-2
|
