| |
TM 9-2350-287-20-2
15-24. CANISTER DOORS REPAIR (continued).
1.
2.
3.
4.
b.
1.
2.
3.
c.
Remove two screws (16), Iockwashers (17), and striker (18) from canister door (1). Discard Iockwashers.
Attach endless sling to hoist and lifting lug (19).
WARNING
Door weighs about 150 pounds. Be careful when removing door.
Personnel should stand clear during lifting operations. A swinging or shifting load
may cause severe injury.
NOTE
An assistant is needed to stabilize door while screws are removed.
While assistant supports canister door (1), remove six screws (13), nuts (11), Iockwashers (10), and washers
(9), plate spacer (8), and canister door (1) from vehicle. Discard Iockwashers.
Using hoist and sling, rest canister door (1) on level surface, and remove sling from lifting lug (1 9).
DISASSEMBLY
Remove four screws (3), Iockwashers (4), and washers (5), latch (6), and plate spacer (7) from canister door
(l). Discard Iockwashers.
Remove six screws (14) and Iockwashers (15) and two hinges (12) from canister door (1). Discard
Iockwashers.
Remove pad (2) from canister door (1). Discard pad.
CLEANING AND INSPECTION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open frame or excessive heat.
10
Clean all metal parts with drycleaning solvent. Remove all adhesive residue from canister door (1). Allow to
airdry.
2.
Inspect all parts for cracks, warps, or other damage. Replace unserviceable parts.
d.
ASSEMBLY
WARNING
Adhesives can bum easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. if adhesive gets on skin or clothing, wash immediately with soap and
water.
15-54
|