TM 9-2350-287-20-17-81. PERSONNEL VENTILATION BLOWER REPLACEMENT.This Task Covers:a. Removalb. InstallationInitial Setup:Tool/Test Equipment:l Left projectile rack assembly movedl General mechanic’s tool kit (Item 24,to rear of vehicle (refer to TM 9-2350-287-10).Appendix l)Equipment Conditions:l Vehicle parked on level ground (refer toTM 9-2350-287-10).a.1.2.b.1.2.3.4.REMOVALLoosen two clamps (7) and remove hose (9) from connector(10) and duct (8).Remove three screws (4), six washers (3), and three plates(2) ventilation blower (12) and screen (13) from forwardcargo bulkhead (1) and disconnect electrical connector (6)from receptacle (5) on personnel ventilation blower (1 2).Remove coupling (11) and connector (10) from ventilationblower (12).INSTALLATIONInstall one screw (4) two washers (3) and one plate (2) inforward bulkhead (1).Install connector (10) on ventilation blower (12) and securewith coupling (11).Install screen (13) and connect electrical connector (6) toreceptacle (5) on ventilation blower (1 2).Position ventilation blower (12) on forward cargo bulkhead(1) and secure with two screws (4), four washers (3), twoplates (2).Install two clamps (7) on hose (9). Position hose (9) onconnector (10) and duct (8). Secure hose with clamps (7).FOLLOW-ON MAINTENANCE:l Install left projectile rack assembly (refer to TM 9-2350-287-10).7-261/(7-262 blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
