TM 9-2350-287-20-1
7-44.
ENGINE DISCONNECT BRACKET TO BULKHEAD WIRING HARNESS (12268418-1) REPLACEMENT
(continued).
NOTE
An assistant is required for installation of two electrical connectors in battery
compartment.
11.
Remove hardware from bulkhead and install electrical connector (18) on bulkhead with four screws (17), washers
(19), new lockwashers (20), and nuts (21).
12.
Remove hardware from bulkhead and install electrical connector (13) on bulkhead with four screws (14), washers
(12), new lockwashers (11), and nuts (10).
13.
Connect two electrical connectors (5 and 6) to bulkhead in driver's compartment.
14.
Connect two connectors (2) to two batteries (4) with two screws (1) and nuts (3).
FOLLOW-ON MAINTENANCE:
Connect battery ground cables (para 7-41).
Close transmission access doors (refer to TM 9-2350-287-10).
Change 1 7-135